High-Index Lens Buying Guide: 1.60, 1.67 and 1.71

Clear optical lens sample prepared for product inspection.
Material selection

A higher refractive index is not automatically a better lens. The commercial choice depends on prescription, frame, thickness target, coating, buyer price point and whether the order is finished or semi-finished.

The decision starts with the prescription and frame

High-index material becomes more useful as the prescription, edge thickness or frame demand increases. Two buyers can order the same material at different powers and obtain different appearance and processing requirements, so a material name alone is not a complete specification.

How the three families differ in a buying programme

Family Typical buying role What to verify
1.60 MR-8 Balanced high-index transition Power range, coating route, material TDS and finished-lens test scope.
1.67 MR-7 Thinner programme for higher powers Combined power limits, diameter, coating and representative sample.
1.71 MR-174 Thin premium direction Finished/SF split, availability by power and exact material documentation.

The table is a purchasing framework, not a performance ranking. The approved product fact sheet should be the source of truth.

Do not infer finished-lens performance from the material name

Material datasheets can describe material properties. A claim about the finished lens must identify the article, power, thickness, coating, test method and laboratory scope. For semi-finished blanks, the downstream laboratory controls later generation, edging and assembly steps.

Quote the power mix by band

Send several representative powers instead of one average. Include cylinder limits, prism or special geometry where applicable, and all power combinations that might cause yield, MOQ or delivery limits. This lets the supplier distinguish stock, make-to-order and out-of-range work.

Treat coating as part of the product route

Anti-reflective, hard-coat, hydrophobic and other layers should be named by their approved specification or sample reference. Material index does not determine coating performance, and a coating report does not cover every material or manufacturing site by default.

RFQ checklist

  • Prescription ranges and representative high-volume powers
  • Maximum cylinder or combined-power limits
  • Frame and edge-thickness objective
  • Finished lens or semi-finished blank
  • Diameter, base curve and surface requirement for blanks
  • Coating name, sample reference and appearance standard
  • Material TDS/COA and any finished-product test requirement

Continue the selection

Buyer questions

Is a higher index always the best choice?

No. It is one factor in thickness, appearance, cost and process. The correct choice depends on the power mix, frame and approved commercial target.

Can the supplier confirm impact performance from the material?

The supplier can describe the material evidence, but a finished lens claim should be tied to the tested article and scope. Keep material and finished-product evidence separate.

What should an optical lab send for blanks?

Include material, index, design, diameter, base curve, expected ADD for multifocal work, quantity and any coating or marking requirement.

Need a quotation review?

Send the product family, Finished or SF format, power distribution, coating or colour, quantity, packing and destination. If a certificate, test report or material datasheet is required, state the exact document scope rather than asking only for “certificates”.

Start a structured RFQ