Polarized Lens Buying Guide: VLT, Colour and Base Curve

Clear optical lens sample prepared for product inspection.
Sun lens sourcing

Polarized lens quotations become unreliable when colour, visible light transmittance, base curve and lens format are mixed together. These are separate fields and should remain separate in the RFQ.

Colour and VLT are not the same specification

Colour describes the appearance or spectral character of the lens. VLT describes the proportion of visible light transmitted under the defined measurement conditions. “96% material transmittance” should not be rewritten as the VLT of a finished tinted lens.

Differentiate RX and stock-oriented programmes

A prescription-oriented polarized programme and a stock-oriented plano sun-lens programme can use different base curves, power ranges and packing logic. Quote them as separate families until the supplier confirms overlap.

Base curve and diameter must be explicit

For sun lenses, common planning fields include diameter and base curve. A diameter such as 71, 75 or 80 mm does not define the curve. Ask for the available curve combinations and the finished or SF boundary.

Polarizing film and orientation need a supplier reference

The polarizing component, orientation, colour route and processing method should be identified by the supplier’s approved specification. Do not infer film construction from a tint name.

Test the actual finished product

When a buyer needs a VLT target, polarization performance, impact claim or category statement, define the finished article and the required standard. The test report must correspond to that product and manufacturing scope.

RFQ checklist

  • 1.56 RX-oriented or 1.49 stock-oriented programme
  • Finished or semi-finished format
  • Colour and approved physical sample
  • Target VLT according to a defined test method
  • Diameter and base curve
  • SPH/CYL or blank planning range
  • Polarizing film reference, coating and packing

Continue the selection

Buyer questions

Can a dark-looking lens be specified without VLT?

For many commercial orders, a colour and sample may be enough. For a performance or category requirement, specify the measured VLT target and the method.

Is 2/3/4 base the same as 71/75/80 mm?

No. Base curve and diameter are different dimensions and must be confirmed as an available combination.

Can a material transmittance value be used as VLT?

No. Material transmittance, tint transmission and finished-lens VLT are different measurements unless the report scope proves otherwise.

Need a quotation review?

Send the product family, Finished or SF format, power distribution, coating or colour, quantity, packing and destination. If a certificate, test report or material datasheet is required, state the exact document scope rather than asking only for “certificates”.

Start a structured RFQ